Block off for the center trim the holds the vents, radio, and heater / ac controls
Uses a simple slide on mounting to clamp the trim to the dash for a clean look with no screws and NO DRILLING into the dash to mount it
Available in black ABS Plastic, with multiple surface texture options to save you the time of wrapping our painting
TO INSTALL
1) Start by holding the trim slightly above its normal location in the dash, bottom edge of the trim in the center of the hole. Now with the delete resting against the dash, begin lowering into place. Ensure that the outside face stays on top of the leather exterior, and the rear mounts/guides slide down the back so the delete can wedge on either side of the dash. Slide all the way down until the delete reaches the bottom of the center trim dash hole
2) Next fold in the 2 top corners. The corners will need to be pressed down and inward so the entire panel flexes to tuck in the upper corner mounts
3) For the final step you should have the bottom edge lined up, top corners tucked in, and then continue working the top center tabs down, from the outside edges inward so the center bulge shrinks into the middle. - Push down on the tabs themselves on the top of the delete (move back and forth - left side, right side, left side, right). The top tabs should pop under the dash, and once the final tab goes under the delete will snap in place and flatten against the dash
